Skip to content

How do I write a good request for a Revit model?

AutoMEP reads your model's levels, rooms, systems, panels and loaded families before it changes anything, so a Revit request works best when it uses the names your model uses. Here's a request that does:

"On L2, add two ceiling diffusers in Meeting Room 36 on the Supply Air 1 system, add a control damper in the duct that serves them, and tag both diffusers with their flow."

Use your model's names: if your levels are called L2 or M1, say L2 or M1, not "Level 2". Name rooms by their name or number, systems by their name, such as Supply Air 1 or Domestic Cold Water, and panels by their name, such as LP-2.

Which system a new run joins: new ducts and pipes join a system that's already in your model. Name it if you care which one. If you don't, AutoMEP picks the matching system and says which it used.

Families and types: AutoMEP uses the families already loaded in your model first. To choose one, name the family and type. If your model has nothing that fits, AutoMEP loads a family, from the ones you've uploaded under Settings or from its own component library, and then places it. Where components come from.

Ceiling-hosted families: diffusers and recessed lights that hang on a ceiling go on the underside of the ceiling above the spot you describe, so the level needs ceilings in the model for them.

Dampers and valves in a run: "add a control damper in the supply duct to Meeting Room 36" or "add a backflow preventer on the cold water line to the kitchen". AutoMEP cuts the duct or pipe, sizes the accessory to it and joins it into the run, so the system stays connected. Two accessories in one run work when the run is long enough for both.

Connecting to what's there: a new branch that ends on an existing main is joined to it with a tee, and two runs that meet get an elbow, so ask for the connection in the same request: "run a new branch from the cold water main to the new sink and connect it".

Circuits: "add four light fixtures in Office 104 and circuit them to panel LP-2". Voltage and poles come from the fixtures and the panel.

Sizes: give the unit with the size, for example "change the drain in Restroom 2 from 3 inch to 4 inch". Pipes keep to standard sizes.

Tags and sheets: "tag every air terminal on L2 with its flow", or "create a sheet for the L2 mechanical plan". A new sheet uses a title block that's already loaded in your model. More on tagging.

Questions: to count or check something, ask it as a question, such as "how many light fixtures are on L3?", and AutoMEP answers it without changing the model.

What you get back: your model in the same Revit release you sent, an exported DWG and a plotted PDF, with a preview in the browser. Revit 2024, 2026 and 2027 models are supported, and a 2025 model is upgraded to 2026 only if you agree. More on Revit support.

One request or several: a Revit request does more work than an AutoCAD one and uses more usage. On a trial or the Starter plan, each request starts again from your original upload, so put everything for one change in one request. On Pro and Team, with Build on the last result ticked, each request adds to the one before.

Not in Revit yet: dimensions, hatching, revision clouds and a bill of materials table, and your uploaded CAD standards and title blocks apply to DWG drawings only. More in what AutoMEP can't do yet.

More in MEP Operations

Did this answer your question? If not, contact support and send us the drawing.