Auto-Route Floor Drains in Revit with AutoMEP
Level L2 of this residential tower has four washer connections and no floor drains. One request asks for a floor drain beside each washer and a two-inch sanitary pipe from each drain into the Building Sanitary system. Each drain comes back joined all the way through: a short drop, an elbow, a two-inch PVC branch and a tee into the existing sanitary run below the floor. AutoMEP uses the model's own floor drain family, tags every branch and hands back the L2 sanitary sheet, P102. Its note says two inches is the size you asked for, not one worked out from fixture units, and that the branches are laid level so you can set the fall.
Read more
- Revit plumbing operations in the Version 1.2 release notes
